This PocketWizard PlusXe Transceiver is designed to wirelessly and remotely trigger cameras or off-camera flashes, and offers an E Release firmware for full compatibility with other PocketWizard radio devices. Key features include:
E Release firmware installed
Transmitter and receiver combo
Enhanced range and reliability
Universal camera and flash compatibility
No. This rental only includes the transceiver.
We have the PocketWizard 3.5mm Sync Cable and PocketWizard Locking PC to 3.5mm Sync Cable available for rent, and a large inventory of 3.5mm shutter release cables you can browse through in the Recommended section of your screen!
1. Turn on the PlusXe
2. Set the dial to Channel 4 and press Test
3. Change the dial to Channel 3 and press Test
4. Change the dial to Channel 2 and press Test
5. Change the dial to Channel 1 and press Test
6. Turn the PlusXe off then on again and the firmware will be set.
When powered on, the radio will blink one bold GREEN blink for Legacy or RED, GREEN, RED, GREEN for E Release.
You can always check out PocketWizard’s Cable Finder to ensure you are renting the correct cables for your setup.
Yes. To operate this device, you will need two AA batteries that will not be included with this rental.
We recommend the Panasonic Eneloop Pro AA Ni-MH 2550mAh 4-pack and the Nitecore New i4 Intellicharger.
Antenna | Precision tuned internal coil |
Battery Life | Up to 100 hours |
Battery Type | (2) AA |
Brand | PocketWizard |
Channels | 10 channels |
Dimensions | (H) 4.2" x (W) 2.1" x (D) 1.2" |
Frequency | FCC/IC: 344.04 MHz |
Inputs/Outputs | 3.5mm (1/8″) stereo miniphone jack |
Antenna | Precision tuned internal coil |
Battery Life | Up to 100 hours |
Battery Type | (2) AA |
Brand | PocketWizard |
Channels | 10 channels |
Dimensions | (H) 4.2" x (W) 2.1" x (D) 1.2" |
Frequency | FCC/IC: 344.04 MHz |
Inputs/Outputs | 3.5mm (1/8″) stereo miniphone jack |